kako se konektovati na net na linux mint 7

[M!L3 H@s!s@R]

LJUDI MOLIM VAS POMOZITE!!!

E OVAKO......KORISTIM Air live WT-2000PCI karticu,kada sam instalirao mint pokazalo mi je da imam konekcije,ali kada odem na firefox...nista"page could be not open".......Molim vas pomozite mi kako da rijesim ovaj problem,jer sam pocetnik na linux-u....unaprijed hvala!

[glaskoncILLa]

sto pise kad u terminL upises ifconfig?

[M!L3 H@s!s@R]

Pise mi:

eth0 Link encap:Ethernet HWaddr 00:1a:4d:f4:11:8e
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:252 Base address:0x4000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:36 errors:0 dropped:0 overruns:0 frame:0
TX packets:36 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2464 (2.4 KB) TX bytes:2464 (2.4 KB)

[glaskoncILLa]

pa, kartica se ne vidi, buduci da bi ta kartica trebala biti podrzana pod linuxom, vjerovatno je down..

upisi;

sudo ifconfig wlan0 up
ifconfig

pa to copy/pasetaj ovdje

za svaki slucaj upisi i;

lspci

cisto da vidimo da li je prepoznata.

[M!L3 H@s!s@R]

ifconfig:

eth0 Link encap:Ethernet HWaddr 00:1a:4d:f4:11:8e
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:252 Base address:0x4000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:52 errors:0 dropped:0 overruns:0 frame:0
TX packets:52 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3616 (3.6 KB) TX bytes:3616 (3.6 KB)

wlan0 Link encap:Ethernet HWaddr 00:4f:6a:04:8e:db
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

wmaster0 Link encap:UNSPEC HWaddr 00-4F-6A-04-8E-DB-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)


lspci:

00:00.0 Host bridge: Intel Corporation 82945G/GZ/P/PL Memory Controller Hub (rev 81)
00:01.0 PCI bridge: Intel Corporation 82945G/GZ/P/PL PCI Express Root Port (rev 81)
00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 01)
00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 01)
00:1c.3 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 4 (rev 01)
00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #1 (rev 01)
00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #2 (rev 01)
00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #3 (rev 01)
00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #4 (rev 01)
00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 01)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC Interface Bridge (rev 01)
00:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family) SATA IDE Controller (rev 01)
00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller (rev 01)
01:00.0 VGA compatible controller: nVidia Corporation GeForce 8500 GT (rev a1)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)
04:01.0 Network controller: RaLink RT2561/RT61 802.11g PCI

[M!L3 H@s!s@R]

i samo da napomenem......sada kada statujem linux,uopste mi vise ne ocitava nikakav signal......prije je pisalo wireless-Lav sargovac 3....pa koliko ima signala,a sada ne pise nista....

[glaskoncILLa]

isto kao i ovdje, instaliraj wicd; http://www.linuxzasve.com/forum/viewtop ... 5&start=10

wicd mozes instalirat tako da u terminal napises;
sudo aptitude install wicd

[M!L3 H@s!s@R]

instalirao sam wicd...i uspjesno se konektovao.....e,kako sad...kada otvorim mozillu opet nista ne otvara,jel treba mozda da u terminal nesto upisem

[glaskoncILLa]

upisi

ifconfig
route -n
cat /etc/resolv.conf

i to sve copy/pastaj ovdje.

[M!L3 H@s!s@R]

milan@milan-desktop ~ $ ifconfig
eth0 Link encap:Ethernet HWaddr 00:1a:4d:f4:11:8e
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:252 Base address:0x6000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:36 errors:0 dropped:0 overruns:0 frame:0
TX packets:36 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2464 (2.4 KB) TX bytes:2464 (2.4 KB)

wlan0 Link encap:Ethernet HWaddr 00:4f:6a:04:8e:db
inet addr:192.168.100.100 Bcast:192.168.100.255 Mask:255.255.255.0
inet6 addr: fe80::24f:6aff:fe04:8edb/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:280 errors:0 dropped:0 overruns:0 frame:0
TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:39141 (39.1 KB) TX bytes:6845 (6.8 KB)

wmaster0 Link encap:UNSPEC HWaddr 00-4F-6A-04-8E-DB-65-64-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

milan@milan-desktop ~ $ route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.100.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0
milan@milan-desktop ~ $ cat /etc/resolv.conf
nameserver 0.0.0.0


i samo da pitam....jel treba da negdje kucam username i pass......mozda u pppoeconf???