Regionalni Linux forum
https://www.linuxzasve.com/forum/
Kod: Označi sve
00:00.0 RAM memory: nVidia Corporation MCP67 Memory Controller (rev a2)
00:01.0 ISA bridge: nVidia Corporation MCP67 ISA Bridge (rev a2)
00:01.1 SMBus: nVidia Corporation MCP67 SMBus (rev a2)
00:01.3 Co-processor: nVidia Corporation MCP67 Co-processor (rev a2)
00:02.0 USB Controller: nVidia Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:02.1 USB Controller: nVidia Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:04.0 USB Controller: nVidia Corporation MCP67 OHCI USB 1.1 Controller (rev a2)
00:04.1 USB Controller: nVidia Corporation MCP67 EHCI USB 2.0 Controller (rev a2)
00:06.0 IDE interface: nVidia Corporation MCP67 IDE Controller (rev a1)
00:07.0 Audio device: nVidia Corporation MCP67 High Definition Audio (rev a1)
00:08.0 PCI bridge: nVidia Corporation MCP67 PCI Bridge (rev a2)
00:09.0 SATA controller: nVidia Corporation MCP67 SATA Controller (rev a2)
00:0a.0 Ethernet controller: nVidia Corporation MCP67 Ethernet (rev a2)
00:0b.0 PCI bridge: nVidia Corporation MCP67 PCI Express Bridge (rev a2)
00:0c.0 PCI bridge: nVidia Corporation MCP67 PCI Express Bridge (rev a2)
00:0d.0 PCI bridge: nVidia Corporation MCP67 PCI Express Bridge (rev a2)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
02:00.0 VGA compatible controller: nVidia Corporation G86 [GeForce 8400M G] (rev a1)
ma nemam taj CD. ne mogu naći opciju enable/disable (10.04 LTS - Unity) , ali nije disable-an(jer nije ni na LiveCDu radio), drivere imam mogućnost instalirati samo za nVidia-inu grafičku.odin je napisao/la:pokušaj ovime http://techie-buzz.com/foss/wifi-on-ubu ... ivers.html
no prije pogledaj dal je wireless enable u network manageru i vidi kaj će ti reć aditional driver installer
pa reko sam da mi NIJE radiloodin je napisao/la:ak je radilo na live cd-u onda treba i saad raditi pa nidswraper i prvi link odma odbacimo.a i driveri su onda instalirani.
ikona od network-managera,desni klik na nju i trebaš imati 2 kvačice
daj i ispisa za ifconfig i iwconfig
Kod: Označi sve
ifconfig
eth0 Link encap:Ethernet HWaddr 00:14:0b:38:31:ae
inet addr:192.168.1.21 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::214:bff:fe38:31ae/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:12026 errors:0 dropped:0 overruns:0 frame:0
TX packets:11522 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11839431 (11.8 MB) TX bytes:1668106 (1.6 MB)
Interrupt:28 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:73 errors:0 dropped:0 overruns:0 frame:0
TX packets:73 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2613 (2.6 KB) TX bytes:2613 (2.6 KB)
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.