Linux za Sve forum

Da li neko zna da li postoji driver za doticni scaner...instalirao sam sane i pokusao skenirat medjutim nece ga prepoznat u Xsane image scanner! molim pomoc...hvala unaprijed

Od nedavno je izgleda podržan.
Treba kompajlirati najnoviji Sane.
Pogledaj ovaj link.
Ovdje isto nešto spominju da bi moglo raditi.
Good luck!

ma kakvi probao sam i to i nazalost opet ne radi :S vjerovatno nemam srece sa tim scannerom :S
ali u svakom slucaju hvala!!!

Trebalo bi raditi ako ga Sane podržava.
Možda su u Lucidu nešto zbrljali pa ne radi.
Probaj možda Koalu ako ti je scanner jako važan.

ne nije mi vazan toliko...uglavnom probat cu jos jednom pa cemo vidjet sta ce bit...hvala jos jednom

Ostavi lsusb za taj skener, pa možemo konkretno tražiti.
Možda netko naleti na rješenje.

$ lsusb
Bus 002 Device 005: ID 03f0:1405 Hewlett-Packard ScanJet 3670
Bus 002 Device 004: ID 03f0:7404 Hewlett-Packard Printing Support
Bus 002 Device 003: ID 046d:c313 Logitech, Inc.
Bus 002 Device 002: ID 1c4f:0003 SiGma Micro
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 005: ID 046d:09a4 Logitech, Inc. QuickCam E 3500
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).

$ sane-find-scanner

# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.

# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.

found USB scanner (vendor=0x03f0, product=0x1405, chip=GL646_HP?) at libusb:002:005
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.

# Not checking for parallel port scanners.

# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.

# You may want to run this program as root to find all devices. Once you
# found the scanner devices, be sure to adjust access permissions as
# necessary.

Evo sve sam copy paste...izgleda da ga ipak ne podrzava... :S

Podržava. Pod sane genesys backendom. I to sve funkcije skenera.
Sad, ja nisam nikad koristio skener na Linuxu pa ti ne znam konkretno reći, ali izgleda da bi ga se dalo natjerati da radi.
Ako shvatim kako, javim.