[Riješeno] EZTV858 USB DVB-T

[Lutherus]

PAE je kratica za Physical Address Extension. PAE patch omogučuje 32 bitnim operacijskim sustavima da adresiraju ram veći od 4 gige.

Za taj stick trebaš ovo

Kod: Označi sve

sudo apt-get install git linux-headers-$(uname -r) build-essential patchutils libproc-processtable-perl
git clone git://linuxtv.org/media_build.git 
cd media_build
./build
sudo make install
sudo reboot

nakon toga otiđi na http://www.linuxtv.org/downloads/firmware/ i skini odgovarajući firmware

pa se otiđi igrati a stick mora biti uštekan. Kompletan firmware trebaš samo prebaciti na odgovarajuće mijesto.

Kod: Označi sve

cd /lib/firmware
cd tvoj kernel
sudo cp ~/dvb-usb-umt-010-02.fw .

e nakon toga odštekaš stick, pričekaš pola minute o minuti i ponovno ga uštekaš.
Kad pokreneš dmesg on će ga učitati. Osim u rijetkim slučajevima gdje taj firmware podiže udev onda napravi ovo

Kod: Označi sve

ps -e | grep udev
sudo /etc/init.d/udev restart

i to je sva mudrost. Filozofiranja ostaju idalje nepotrebna, njih najbolje ostaviti Sokratu.

[Lutherus]

dio 1

Kod: Označi sve

sudo apt-get install git linux-headers-$(uname -r) build-essential patchutils libproc-processtable-perl
git clone git://linuxtv.org/media_build.git 
cd media_build
./build
sudo make install
sudo reboot

zatim dio 2
.

Kod: Označi sve

cd /lib/firmware
cd tvoj kernel
sudo cp ~/dvb-usb-umt-010-02.fw .

a kak ja nađem firmware za njega ak ga nema? https://rapidshare.com/#!download|388p5 ... 7z|745|0|0

inaće ova stvar radi od kernel 2.6.25. Ajde ljepo se smiri i počni pratiti upute.
Ne tebi treba ovo af9005.fw a to je firmware.



da se opet ne ponavljam. sve ima.

[Tomislav001]

napravio sam to kako si rekao ali opet isto

[ 829.232302] usb 1-1.2: new high-speed USB device number 11 using ehci_hcd
[ 829.330131] it913x: Chip Version=01 Chip Type=9135
[ 829.332124] it913x: Remote propriety (raw) mode
[ 829.332629] it913x: Dual mode=0 Tuner Type=0
[ 829.334636] usb 1-1.2: dvb_usb_v2: found a 'ITE 9135(9005) Generic' in cold state
[ 829.341097] usb 1-1.2: dvb_usb_v2: Did not find the firmware file 'dvb-usb-it9135-01.fw'. Please see linux/Documentation/dvb/ for more details on firmware-problems. Status -2
[ 829.341112] usb 1-1.2: dvb_usb_v2: 'ITE 9135(9005) Generic' error while loading driver (-2)
[ 829.341135] usb 1-1.2: dvb_usb_v2: 'ITE 9135(9005) Generic' successfully deinitialized and disconnected
[ 878.283732] udevd[3653]: starting version 175

[Lutherus]

evo ti step by step http://www.et-view-support.com/Forum/sh ... ep-by-step

vidi čak i source nađem za firmware https://github.com/OpenELEC/dvb-firmwar ... ter/it9135

molim te prati gore link sa step by step uputama

[Tomislav001]

evo radi:

[ 1719.657894] usb 1-1.2: USB disconnect, device number 14
[ 1730.096291] usb 1-1.2: new high-speed USB device number 15 using ehci_hcd
[ 1730.194377] it913x: Chip Version=01 Chip Type=9135
[ 1730.196374] it913x: Remote propriety (raw) mode
[ 1730.196876] it913x: Dual mode=0 Tuner Type=0
[ 1730.198878] usb 1-1.2: dvb_usb_v2: found a 'ITE 9135(9005) Generic' in cold state
[ 1730.203354] usb 1-1.2: dvb_usb_v2: downloading firmware from file 'dvb-usb-it9135-01.fw'
[ 1730.203836] it913x: FRM Starting Firmware Download
[ 1730.524249] it913x: FRM Firmware Download Completed - Resetting Device
[ 1730.561648] it913x: Chip Version=01 Chip Type=9135
[ 1730.562143] it913x: Firmware Version 204869120
[ 1730.633649] usb 1-1.2: dvb_usb_v2: found a 'ITE 9135(9005) Generic' in warm state
[ 1730.635660] usb 1-1.2: dvb_usb_v2: will pass the complete MPEG2 transport stream to the software demuxer
[ 1730.635988] DVB: registering new adapter (ITE 9135(9005) Generic)
[ 1730.681891] it913x-fe: ADF table value :00
[ 1730.686767] it913x-fe: Crystal Frequency :12000000 Adc Frequency :20250000 ADC X2: 01
[ 1730.732878] it913x-fe: Tuner LNA type :38
[ 1730.794029] usb 1-1.2: DVB: registering adapter 0 frontend 0 (ITE 9135(9005) Generic_1)...
[ 1730.832088] Registered IR keymap rc-it913x-v2
[ 1730.832328] input: ITE 9135(9005) Generic as /devices/pci0000:00/0000:00:02.1/usb1/1-1/1-1.2/rc/rc0/input15
[ 1730.832485] rc0: ITE 9135(9005) Generic as /devices/pci0000:00/0000:00:02.1/usb1/1-1/1-1.2/rc/rc0
[ 1730.832495] usb 1-1.2: dvb_usb_v2: schedule remote query interval to 250 msecs
[ 1730.832505] usb 1-1.2: dvb_usb_v2: 'ITE 9135(9005) Generic' successfully initialized and connected
root@Tomislav-PC:/home/tomislav#
hvala dečki

[Tomislav001]

da... i kako sad namjestit da radi sa programima:mythtv ili caffeine

[Lutherus]

moraš potražiti kodove kanala kojeg želiš gfledati i onda skenirati. da uzmeš možda vlc?

[Tomislav001]

našao sam Me TV on radi dobro

[Lutherus]

ok