Kako uključiti i prikazati hardware senzore (temp,volt,fans)

[kaiwan]

a pod sensors-applet imam samo temeraturu CPUa ..

[Grof]

tebi koda imaš kakve broken pakete.

Da probaj malo purgati bazu....

[kaiwan]

kako ?

[kaiwan]

autoremove sam napravio ... dobijem istu gresku

[Grof]

apt-get is a simple command line interface for downloading and
installing packages. The most frequently used commands are update
and install.

Commands:
update - Retrieve new lists of packages
upgrade - Perform an upgrade
install - Install new packages (pkg is libc6 not libc6.deb)
remove - Remove packages
purge - Remove and purge packages
source - Download source archives
build-dep - Configure build-dependencies for source packages
dist-upgrade - Distribution upgrade, see apt-get(8)
dselect-upgrade - Follow dselect selections
clean - Erase downloaded archive files
autoclean - Erase old downloaded archive files
check - Verify that there are no broken dependencies

evo, ovo boldano probaj. purge se koristi sa imenom paketa kojeg mičeš..

[kaiwan]

autoclean proslo bez greski
check isto

purge javio istu gresku, da lm-sensnors nije configuriran

[Grof]

Fakat mi nije jasno. Oni se i tako konfiguriraju kasnije sa sensors-detect naredbom...

Ne znam što da ti kažem... sutra ćemo nastaviti, umor me fata....

[kaiwan]

ok

[iv@n]

Kod: Označi sve

sudo apt-get install lm-sensors

Kod: Označi sve

sudo apt-get install hddtemp

Kod: Označi sve

sudo sensors-detect

...na ovo zadnje sve udri YES, ne samo lupit enter, već upisati YES!

Instaliraj si i GUI za pračenje:

Kod: Označi sve

sudo apt-get install sensors-applet

[kaiwan]

al ne mogu instalirat lm-sensors ... javlja mi onu gore navadenu gresku